RE: Transparent Bridging ?

From: R. Scott King (scking@xxxxxxxxx)
Date: Fri Aug 10 2001 - 14:05:01 GMT-3

• Next message: Yves Fauser: "Re: DLSw and port 2067"
• Previous message: R. Scott King: "RE: You know a 1 day remote lab would not be limited to small number of Devices."
• Maybe in reply to: sanjay: "Transparent Bridging ?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
I think that the problem is that loopbacks don't support bridging. At all.

Scott King

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
sanjay
Sent: Thursday, August 09, 2001 3:27 PM
To: ccielab@groupstudy.com
Subject: Transparent Bridging ?

How to configure Transparent bridging between a ethernet interface and
loopback interface on the same router. I know the commands are something
like
this:

bridge 1 protocol ieee (at the global config level)

and then assign the bridge group to the interface. I can put the
"bridge-group
1" command under ethernet, but loopback interface doesn't accept the
bridge-group 1 command. The message is "loopback doesn't support bridging"
Any ideas ?

thanks,
Sanjay
**Please read:http://www.groupstudy.com/list/posting.html
**Please read:http://www.groupstudy.com/list/posting.html

• Next message: Yves Fauser: "Re: DLSw and port 2067"
• Previous message: R. Scott King: "RE: You know a 1 day remote lab would not be limited to small number of Devices."
• Maybe in reply to: sanjay: "Transparent Bridging ?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:48 GMT-3