From: Jay Hennigan (jay@xxxxxxxx)
Date: Thu Aug 09 2001 - 20:15:52 GMT-3
On Thu, 9 Aug 2001, sanjay wrote:
> How to configure Transparent bridging between a ethernet interface and
> loopback interface on the same router. I know the commands are something like
> this:
>
> bridge 1 protocol ieee (at the global config level)
>
> and then assign the bridge group to the interface. I can put the "bridge-grou
p
> 1" command under ethernet, but loopback interface doesn't accept the
> bridge-group 1 command. The message is "loopback doesn't support bridging"
> Any ideas ?
I'm not sure what you're trying to accomplish by bridging to a loopback.
It sounds like you might want to look into creating a BVI (Bridge Virtual
Interface) which is a logical interface similar to a loopback for
bridging applications.
-- Jay Hennigan - CCIE #7880 - Network Administration - jay@west.net NetLojix Communications, Inc. - http://www.netlojix.com/ WestNet: Connecting you to the planet. 805 884-6323 **Please read:http://www.groupstudy.com/list/posting.html
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:31:48 GMT-3