Rate Limiting Question

From: Dan (dp595@xxxxxxxxxxxxx)
Date: Sun Feb 11 2001 - 16:20:07 GMT-3

• Next message: Johnny Dedon: "Re: ccbootcamp lab #1 AGAIN..."
• Previous message: Steven Weber: "Re: ccbootcamp lab #1 AGAIN..."
• Next in thread: Devender Singh: "RE: Rate Limiting Question"
• Maybe reply: Devender Singh: "RE: Rate Limiting Question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
What is the difference between using these 2 different commands in order =
to rate limit on an interface?

"rate-limit"

or

"traffic-shape"

Can both commands be used for rate-limiting? I have noticed that the =
"rate-limit" interface command is only available on higher Cisco =
platforms such as 75xx, and on lower platforms I must use =
"traffice-shape"

Thanks.

Dan Pontrelli

• Next message: Johnny Dedon: "Re: ccbootcamp lab #1 AGAIN..."
• Previous message: Steven Weber: "Re: ccbootcamp lab #1 AGAIN..."
• Next in thread: Devender Singh: "RE: Rate Limiting Question"
• Maybe reply: Devender Singh: "RE: Rate Limiting Question"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:45 GMT-3