From: DERY, FREDERIC (frederic.dery@xxxxxxxxxxx)
Date: Wed Jul 26 2000 - 11:13:16 GMT-3
Try with a dialer interface. I think this should solve your problem.
Frederic
Geatti wrote:
>
> Nice catch on the Broadcast statement on R2 Xuping - thanks.
> Still doesn't work though. I've tried RIP, IGRP, EIGRP and OSPF, none of
> them work over my POTS connection.
> I do a debug ip RIP and all I get is updates send to the loopbacks, it's as
> if the routing process doesn't know that the async 1 interface exists on
> either router in order to send the broadcast/multicast out, even though it
> is included in the RIP process as 10.0.0.0 and both status and protocol are
> UP UP.
>
> Ping :-) can ping and telnet through line all day works fine
> Route :-( routing broke.
>
> Appreciate any contributions,
> Marco
>
> (Router2-aux)---modem-------modem----(aux-Router3)
>
> R3 config - (has loop of 3.3.3.3 255.255.255.0)
>
> interface Async1
> ip address 10.10.10.1 255.255.255.0
> ip directed-broadcast
> encapsulation ppp
> dialer in-band
> dialer idle-timeout 200
> dialer map ip 10.10.10.2 name R2 modem-script fred broadcast 40
> dialer-group 1
> async dynamic routing
> async mode dedicated
> ppp authentication chap
>
> router rip
> network 10.0.0.0
> network 3.0.0.0
>
> R2 config - (has loop of 2.2.2.2 255.255.255.0)
>
> interface Async1
> ip address 10.10.10.2 255.255.255.0
> encapsulation ppp
> async dynamic routing
> async mode dedicated
> dialer in-band
> dialer map ip 10.10.10.1 name R3 broadcast
> ppp authentication chap
>
> router rip
> network 10.0.0.0
> network 2.0.0.0
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> xuping
> Sent: Tuesday, July 25, 2000 9:20 PM
> To: Geatti; ccielab@groupstudy.com
> Subject: async routing
>
> >R2 config
> >
> >interface Async1
> > ip address 10.10.10.2 255.255.255.0
> > encapsulation ppp
> > async dynamic routing
> > async mode dedicated
> > dialer in-band
> > dialer map ip 10.10.10.1 name R3
> > ppp authentication chap
>
> Hi
>
> in R2 dialer map, add "brocast", since most routing protcol use brocast or
> multicast.
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:58 GMT-3