AppleTalk Tunnel

From: hon-siong chan (honsiong@xxxxxxxxxxx)
Date: Thu Apr 27 2000 - 07:23:44 GMT-3

• Next message: certman: "ATM,VPN,DLSW"
• Previous message: clou@xxxxxxxxxxxxxx: "Re: CCIE # 5832"
• Next in thread: Erik Belz: "Re: AppleTalk Tunnel"
• Maybe reply: Erik Belz: "Re: AppleTalk Tunnel"
• Maybe reply: Li Chaoyong (Company): "Re: AppleTalk Tunnel"
• Maybe reply: John Garrett: "Re: AppleTalk Tunnel"
• Maybe reply: John Garrett: "Re: AppleTalk Tunnel"
• Maybe reply: Erik Belz: "Re: AppleTalk Tunnel"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
HI group,

If I need to set-up appletalk tunnel using AURP encapsulation, is that right
I need to configure the following:

1) Create an "interface tunnel 0"
2) Specify tunnel source & destination address
3) enable "tunnel mode" to AURP
4) Specify "appletalk protocol aurp" command
5) create an appletalk cable range for interface tunnel 0

Do I need to also create appletalk zone for tunnel 0? Do I need to configure
the same for opposite directly connected router too?

Clarification on the above is much appreciated!

Thanks GROUP!

Regards
HonSiong

• Next message: certman: "ATM,VPN,DLSW"
• Previous message: clou@xxxxxxxxxxxxxx: "Re: CCIE # 5832"
• Next in thread: Erik Belz: "Re: AppleTalk Tunnel"
• Maybe reply: Erik Belz: "Re: AppleTalk Tunnel"
• Maybe reply: Li Chaoyong (Company): "Re: AppleTalk Tunnel"
• Maybe reply: John Garrett: "Re: AppleTalk Tunnel"
• Maybe reply: John Garrett: "Re: AppleTalk Tunnel"
• Maybe reply: Erik Belz: "Re: AppleTalk Tunnel"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:16 GMT-3