From: Erik Belz (ebelz@xxxxxxxxxx)
Date: Thu Apr 27 2000 - 21:52:18 GMT-3
You do not configure any cable-range or zones on tunnel interface....
Erik C Belz
Senior systems engineer
Manchester Equipment Co
(212)560-5459
>>> "hon-siong chan" <honsiong@hotmail.com> 04/27/2000 6:23:44 AM >>>
HI group,
If I need to set-up appletalk tunnel using AURP encapsulation, is that right
I need to configure the following:
1) Create an "interface tunnel 0"
2) Specify tunnel source & destination address
3) enable "tunnel mode" to AURP
4) Specify "appletalk protocol aurp" command
5) create an appletalk cable range for interface tunnel 0
Do I need to also create appletalk zone for tunnel 0? Do I need to configure
the same for opposite directly connected router too?
Clarification on the above is much appreciated!
Thanks GROUP!
Regards
HonSiong
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:16 GMT-3