From: Li Chaoyong (Company) (hughcyli@xxxxxxxxxxxxxxxxx)
Date: Fri Apr 28 2000 - 05:45:16 GMT-3
You don't need configure cable range
----- Original Message -----
From: hon-siong chan <honsiong@hotmail.com>
To: <ccielab@groupstudy.com>
Sent: Thursday, April 27, 2000 6:23 PM
Subject: AppleTalk Tunnel
> HI group,
>
> If I need to set-up appletalk tunnel using AURP encapsulation, is that right
> I need to configure the following:
>
> 1) Create an "interface tunnel 0"
> 2) Specify tunnel source & destination address
> 3) enable "tunnel mode" to AURP
> 4) Specify "appletalk protocol aurp" command
> 5) create an appletalk cable range for interface tunnel 0
>
> Do I need to also create appletalk zone for tunnel 0? Do I need to configure
> the same for opposite directly connected router too?
>
> Clarification on the above is much appreciated!
>
> Thanks GROUP!
>
> Regards
> HonSiong
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:16 GMT-3