Re: EIGRP with HSRP Question.

JB,

Tweak the metric "delay", add a line delay xxx to the eigrp enabled
interface on R2 and R3. You have to set it at the core s/w as well.

And R1 will be preferred for ingress and egress, if that's what you were
looking for.
Best Regards,
Tharak Abraham Luke

On Fri, Feb 8, 2013 at 9:41 AM, Johnny Morris <johnnymorris01_at_gmail.com>wrote:

> Please paste show ip route 192.168 .0 .0 from your wan router
>
> HSRP is highest priority
> On Feb 7, 2013 11:00 PM, "JB Poplawski" <jb.poplawski_at_gmail.com> wrote:
>
> > Both core routers/switches advertise the same subnet. WAN Router sees
> > both routes, but prefers the higher IP (or so it seems).
> >
> > If I had 5 routers, highest IP wins, right? If that's the case, I need
> to
> > get my primary HSRP/STP Switch to have the higher IP in the group.
> >
> > Trying to avoid any latency or additional hop in this solution.
> >
> >
> > On Thu, Feb 7, 2013 at 9:41 PM, marc edwards <renorider_at_gmail.com>
> wrote:
> >
> >> Take advertisement off R1 and let it advertise all specific subnets in
> >> 192.168. Hard to say what without knowing what is attempting to be
> >> accomplished. When you say Router 2 leads the pack, I assume that this
> >> is from the view of your WAN router?Again without knowing exactly what
> >> is trying to be accomplished, if this is for lab or real design makes
> >> it tough to validate any decisions. But I can guarantee that longest
> >> prefix match will be the #1 routing selection and easiest to change by
> >> simply removing R1's summary.
> >>
> >> Regards,
> >>
> >> Marc
> >>
> >> On Thu, Feb 7, 2013 at 4:26 PM, Johnny Morris <johnnymorris01_at_gmail.com
> >
> >> wrote:
> >> > What is your IGP ? You wouldn't necessarily mess with HSRP to
> influence
> >> an
> >> > outbound route to a neighbor, You can use an offset-list for example
> >> with
> >> > EIGRP on the two routers facing the 3rd router and reference an ACL
> with
> >> > the redistributed static route going to your third router. I would
> look
> >> at
> >> > the metric that is being received from both routers and offset it
> >> depending
> >> > on your IGP or routing protocol. For example of the route was received
> >> with
> >> > the same metric and you had two routes to get to the network you could
> >> do
> >> > the following with eigrp:
> >> >
> >> > An example would be
> >> >
> >> > R1
> >> >
> >> > router eigrp 1
> >> >
> >> > red static
> >> >
> >> > Offset- list 1 out 132000 INTERFACE
> >> >
> >> > access-list 1 p 192.168.0.0
> >> >
> >> > ip route 192.168.0.0 255.255.0.0 x.x.x.x
> >> >
> >> >
> >> > R2
> >> >
> >> > router eigrp 1
> >> >
> >> > red static
> >> >
> >> > Offset- list 1 out 132500 INTERFACE
> >> >
> >> > access-list 1 p 192.168.0.0
> >> >
> >> > ip route 192.168.0.0 255.255.0.0 x.x.x.x
> >> >
> >> >
> >> > Again depends on your routing protocol you are running between the
> >> routers,
> >> > because you mentioned Variance I assume you are running EIGRP.
> >> >
> >> >
> >> > On Feb 7, 2013 6:23 PM, "JB Poplawski" <jb.poplawski_at_gmail.com>
> wrote:
> >> >
> >> >> Good afternoon,
> >> >>
> >> >> Have a scenario, it might be nit-picky, but figured I should ask.
> >> >>
> >> >> I have two routers running HSRP
> >> >> HSRP VIP - 192.168.1.1
> >> >> Router 1 Active - 192.168.1.2
> >> >> Router 2 Standby - 192.168.1.3
> >> >>
> >> >> Both routers are redistributing static for a network summary.
> >> >> 192.168.0.0/16
> >> >>
> >> >> I have an additional WAN router that comes in and is on that same
> >> Layer 3
> >> >> subnet.
> >> >>
> >> >> WAN - 192.168.1.10
> >> >>
> >> >> If I do a show ip route 192.168.0.0, I see both routers advertising
> the
> >> >> summary, Router 2 is leading the pack for who owns that route. My
> >> Router 1
> >> >> is both the VIP holder AND STP root, though.
> >> >>
> >> >> What am I doing wrong? I assume I can add distance statement and
> drop
> >> the
> >> >> standby down a peg or two. Are there any cleaner ways? Drop
> variance
> >> >> down?Any help is greatly appreciated.
> >> >>
> >> >> Regards,
> >> >> JB
> >> >>
> >> >>
> >> >> Blogs and organic groups at http://www.ccie.net
> >> >>
> >> >>
> _______________________________________________________________________
> >> >> Subscription information may be found at:
> >> >> http://www.groupstudy.com/list/CCIELab.html
> >> >
> >> >
> >> > Blogs and organic groups at http://www.ccie.net
> >> >
> >> >
> _______________________________________________________________________
> >> > Subscription information may be found at:
> >> > http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Fri Feb 08 2013 - 11:37:05 ART