Re: Basic PIX - Transparent mode

I think u need to configure NAT.

On Tue, Jul 24, 2012 at 11:07 PM, Vibeesh S <vibselva_at_gmail.com> wrote:

> Hi Guys,
>
> ~This is a test env
>
> Router ---- E3 PIX E0---- Server
>
> The E3 is set as inside & E0 as Outside with lower security level. I want
> to allow all traffic from router to Server for now. The PIX is in
> transparent mode. The PIX does not have any config on.
>
> Cisco says by default all L3 traffic should be allowed from higher to lower
> security level interface
>
> http://www.cisco.com/en/US/docs/security/asa/asa80/configuration/guide/fwmode.html#wp1201980
>
> But nothing is going though even if i add access list.
> Appeciate your help.
>
> Thanks,
> Vibs
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Tue Jul 24 2012 - 23:12:07 ART