Validate Update source command - RIP

Hello All,

I am stuck and need your help.

BB1---connected to R1 and is configured with a different subnet. Both run
Rip v2 but are not reachable. I did configure no validate source command
and I was able to see all the routes from BB1 in R1 routing table. When I
ping from R1 to those routes they were not reachable so I created a static
route and I was able to reach those ips.

Now in the network where R1 is connected to other routers, from those
devices I am able to reach R1 ip address at the same time I do see all the
routes in the routing table which come from BB1. But those IPs are not
reachable. When I did a traceroute the packet goes till R1 but there is no
response from there on.

I am not sure what needs to be done and I am failing here.

Please assist.

Mohammed Aftab Memon

Blogs and organic groups at http://www.ccie.net
Received on Wed Jun 06 2012 - 14:30:18 ART