Re: Validate Update source command - RIP

Instead of a static route, advertise the subnet between R1 and BB1 so that you have next hop reachability for upstream routers.

Regards,
Jay McMickle- CCIE #35355 (R&S)
Sent from iJay

On Jun 6, 2012, at 4:00 AM, Mohammed Aftab Memon <aftabmemon12_at_gmail.com> wrote:

> Hello All,
>
> I am stuck and need your help.
>
> BB1---connected to R1 and is configured with a different subnet. Both run
> Rip v2 but are not reachable. I did configure no validate source command
> and I was able to see all the routes from BB1 in R1 routing table. When I
> ping from R1 to those routes they were not reachable so I created a static
> route and I was able to reach those ips.
>
>
> Now in the network where R1 is connected to other routers, from those
> devices I am able to reach R1 ip address at the same time I do see all the
> routes in the routing table which come from BB1. But those IPs are not
> reachable. When I did a traceroute the packet goes till R1 but there is no
> response from there on.
>
> I am not sure what needs to be done and I am failing here.
>
> Please assist.
>
> Mohammed Aftab Memon
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Wed Jun 06 2012 - 08:00:14 ART