Re: OT:cisco 6500 runing configration..help??

Sup-bootflash:

In rommon check your boot via
    Rommon> set
    

If the return value is what you want, run the command boot "then the value shown in the set settings" f the value in the set return values is wrong use the command set boot: xxxxxx

Where xxxx is the location of your .bin image.

I've had these problems with stubborn 6506's in the past when someone at a customer site tries to do craziness and jacks the boot order.

Regards,
 Joe Sanchez

On Jan 25, 2012, at 6:02 AM, muhammad adnan <taurusadnan19_at_gmail.com> wrote:

> i fix everything but when i unplugged the 6509 power cord then switch lost
> his startup config and boot config on SP(switch processor)
> and switch goes into rommon monitor mode then i put to manually the boot
> command at rommon and manually copy the
> startup-config into the runing-config and also restore the vlan.dat file
> manually.
>
>
> kindly help me in this regard
>
> Thanks
> Muhammad Adnan
>
>
> On Tue, Jan 24, 2012 at 11:52 PM, kennypual <pdaramol_at_gmail.com> wrote:
>
>> Also check your remote switch config register setting
>>
>>
>>
>> On Tue, Jan 24, 2012 at 11:08 AM, muhammad adnan <taurusadnan19_at_gmail.com>wrote:
>>
>>> my config reg was configured as 0x2102 but i change it to the 0x2101.
>>> After
>>> that when i put #config t command on switch it give me error message.
>>>
>>> Router#conf t
>>>
>>> % Warning: Waiting for draco inventory message from SP.
>>>
>>> % Reload MSFC without saving configuration if the MSFC does not r
>>>
>>> ecover.
>>> % Configuration allowed only from Primary
>>>
>>> any one kindly help on this error
>>> Thanks
>>>
>>>
>>> On Tue, Jan 24, 2012 at 8:48 PM, Michael Seonarain <mseonarain_at_gmail.com
>>>> wrote:
>>>
>>>> It is stored in nvram and check the config-register setting..
>>>>
>>>> On Tue, Jan 24, 2012 at 5:59 AM, muhammad adnan <
>>> taurusadnan19_at_gmail.com>wrote:
>>>>
>>>>> Hello to all group members:-
>>>>> i want to know where the startup
>>>>> configration of cisco 6500 switch save.i am facing a problem when i
>>> unplug
>>>>> the power of the switch i lost my startup configration and switch boots
>>>>> with default configuration.kindly help me on this matter.
>>>>>
>>>>>
>>>>>
>>>>>
>>>>>
>>>>> Thanks a lot
>>>>> Muhammad Adnan
>>>>>
>>>>>
>>>>> Blogs and organic groups at http://www.ccie.net
>>>>>
>>>>> _______________________________________________________________________
>>>>> Subscription information may be found at:
>>>>> http://www.groupstudy.com/list/CCIELab.html
>>>
>>>
>>> Blogs and organic groups at http://www.ccie.net
>>>
>>> _______________________________________________________________________
>>> Subscription information may be found at:
>>> http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Wed Jan 25 2012 - 07:16:18 ART