Re: OT:Tengig Ports not connected error

Faizan,

I have the same opinion. Please check the link sent by Max.

"To configure the modes of operation for each X2 port group in which you
want to deploy Gigabit, enter the hw-module module <m> port-group <p>
select gigabitethernet command. "

Rgs,

2012/1/22 N. Max Pierson <nmaxpierson_at_gmail.com>

> Hi Faizan,
>
> Have you configured the module to support 1g instead of 10g (10g is the
> default)???
>
>
> http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/46sg/configuration/guide/sw_int.html#wp1077316
>
>
> HTH's,
>
> max
>
> On Sun, Jan 22, 2012 at 6:14 AM, faizan khurshid <
> faizankhurshid921_at_hotmail.com> wrote:
>
> > Hi Experts
> >
> > I have one Core WS-C4510R-E with WS-X45-SUP6-E .Im geeting following
> > error
> > once i reboot my Switch .A device can detect 10G ports but status remain
> > down
> > even using no shut commands
> >
> > I have TwinTenGig Converter installed on Core Switch
> >
> >
> > C4K_GLMMAN-3-X2PLUGGABLESEEPROMREADFAILED:
> > Failed to read seeprom on port Te2/8. Reinsert X2 module or configure
> > GigabitEthernet port group if TwinGigConverter is installed.
> >
> >
> > Any suggestion help will be highly appreciated
> >
> >
> > Regards
> >
> > Faizan Khurshid
> >
> >
> > Blogs and organic groups at http://www.ccie.net
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

-- 
Alessandro Braga
CCIE #30939
Blogs and organic groups at http://www.ccie.net