Re: Error on etherchanel on Cisco 6509

Remove interface port channel config remove physical ports from channel-group command , default those Ports back to blank interface configuration..

Go back into the physical interfaces you wish to bundle, put in your channel-group 23 mode active config... Create interface po23 and put in your configuration again. Do a show run int g6/x to see if everything from your PO was carrier into your physical port.

Regards,
 Joe Sanchez

On Dec 19, 2011, at 10:17 PM, "Thanh Tran" <thanhtran84_at_gmail.com> wrote:

> Dear expert,
>
>
>
> I configured the ether-channel on 5 port G4/26 to 28 (slot 4) and G6/13 to
> 14 (slot 6) on Cisco 6509V-E. And it generated an error
>
> *Dec 20 04:05:33.639: %EC-SP-5-CANNOT_BUNDLE_LACP: Gi4/28 is not compatible
> with aggregators in channel 32 and cannot attach to them (flow control send
> of Gi4/28 is on, Gi4/27 is off)
>
>
>
> I try to turn on the flow control on G4/27, then it generated an different
> error
>
> *Dec 20 04:05:33.639: %EC-SP-5-CANNOT_BUNDLE_LACP: Gi4/28 is not compatible
> with aggregators in channel 32 and cannot attach to them (flow control send
> of Gi4/27 is disagree , Gi4/28 is on)
>
>
>
> Could someone help?
>
>
>
> Thanks a lot.
>
>
>
> Regards,
>
>
>
> Thanh Tran
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Tue Dec 20 2011 - 01:11:33 ART