frame-relay encapsulation mismatch

Dear all

if the encapsulation dosent match on between two frame-realy router doest it
logical to think circuit will break ?

R1#show frame-relay map
Serial0/0 (up): ip 10.0.0.3 dlci 103(0x67,0x1870), static,
              broadcast,
              CISCO, status defined, active

R3#sh frame-relay map
Serial0/1 (up): ip 10.0.0.1 dlci 301(0x12D,0x48D0), static,
              broadcast,
              IETF, status defined, active
              CISCO, status defined, active

R1#ping 10.0.0.3
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 10.0.0.3, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 40/51/80 ms
R1#

both are connected and reachable .....yet their is mismatch in encapsulatin
type ...

why ?

Blogs and organic groups at http://www.ccie.net
Received on Sat Jun 18 2011 - 18:13:31 ART