FULL Status LMI request interval change......

Hi GS,
Some very basic question about frame-relay. A task asked me to change full
status LMI request interval to half of original values. Interface showed me
that i m using Annex D type LMI

R1(config-if)#do sh int s0/0 | inc LMI type
  LMI DLCI 0 LMI type is ANSI Annex D frame relay DTE segmentation
inactive

ok good to see but what i should select from the given below to adjust
event? cannot find any hint on google.

R1(config-if)#frame-relay lmi-?
lmi-n391dte lmi-n392dce lmi-n392dte lmi-n393dce
lmi-n393dte lmi-t392dce lmi-type

Any help will be highly appreciated.

Best Regards,

Nadeem Rafi

Blogs and organic groups at http://www.ccie.net
Received on Mon Dec 06 2010 - 09:57:49 ART