Re: FULL Status LMI request interval change......

Has to be a DTE command .

Check this :

rame-relay lmi-n391dte

To set a full status polling interval, use the frame-relay lmi-n391dte
interface configuration command. To restore the default interval
value, assuming that a Local Management Interface (LMI) has been
configured, use the no form of this command.

frame-relay lmi-n391dte keep-exchanges

no frame-relay lmi-n391dte keep-exchanges
Syntax Description

keep-exchanges
        

Number of keep exchanges to be done before requesting a full status
message. Acceptable value is a positive integer in the range from 1
through 255.

Defaults

6 keep exchanges

So now u have a hint

Thnx
Gaurav Madan

On Mon, Dec 6, 2010 at 12:27 PM, Nadeem Rafi <nrafia_at_gmail.com> wrote:
> Hi GS,
> Some very basic question about frame-relay. A task asked me to change full
> status LMI request interval to half of original values. Interface showed me
> that i m using Annex D type LMI
>
> R1(config-if)#do sh int s0/0 | inc LMI type
> LMI DLCI 0 LMI type is ANSI Annex D frame relay DTE segmentation
> inactive
>
> ok good to see but what i should select from the given below to adjust
> event? cannot find any hint on google.
>
> R1(config-if)#frame-relay lmi-?
> lmi-n391dte lmi-n392dce lmi-n392dte lmi-n393dce
> lmi-n393dte lmi-t392dce lmi-type
>
> Any help will be highly appreciated.
>
>
> Best Regards,
>
> Nadeem Rafi
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Mon Dec 06 2010 - 12:30:58 ART