RE: Inverse-ARP with no LMI

Hi Muzammil,

Frame Relay Inverse ARP should work fine without LMI; I believe your
connectivity problem lies elsewhere.

If you disable keepalives on the router, DTE, side, you must also do so on
the other side of the link, the DCE side. Looking over your configuration,
I would note that the interface-dlci command is unnecessary; all pvcs will
be associated automatically with the physical interface.

HTH,

Bob Sinclair CCIE 10427 CCSI 30427
CIERS2 Online Instructor
www.tinyurl.com/ciers2online

> -----Original Message-----
> From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
> Muzammil Malick
> Sent: Sunday, October 17, 2010 9:58 AM
> To: Cisco certification
> Subject: Inverse-ARP with no LMI
>
> Hi all
>
> When I have the following config I have no problems with connectivity
> and I can see inverse-arp requests and replies:
>
>
> interface Serial1/0
> ip address 10.0.0.1 255.255.255.0
> encapsulation frame-relay IETF
> serial restart-delay 0
> frame-relay interface-dlci 102
> end
>
> However when I switch off LMI on the interface (below) I can only see
> inverse-arp requests but no replies and so ping fails. Is inverse-arp
> dependent on LMI?
>
> interface Serial1/0
> ip address 10.0.0.1 255.255.255.0
> encapsulation frame-relay IETF
> no keepalive
> serial restart-delay 0
> frame-relay interface-dlci 102
> end
>
> Thanks
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
> No virus found in this incoming message.
> Checked by AVG - www.avg.com
> Version: 9.0.862 / Virus Database: 271.1.1/3202 - Release Date:
> 10/17/10 02:33:00

Blogs and organic groups at http://www.ccie.net
Received on Sun Oct 17 2010 - 12:00:43 ART