Re: E1 interface

Okay....
Radwin is the OEM and the radio has 3 brands (its own by Rad
datacommuncation rad.com)

- Ceragon - they sell it as a FA-4800
- Radwin - winlink1000
- Rad data - Airmux 200

All 3 have same firmware configuration menus. no difference.

I believe the radio you've provides ethernet + 4E1 or just 4E1.

In default mode the wizard configures E1 on radio as a "Unframed". So you
should be okay by conifguring your both router E1 port as a framed at both
end.

PS: I know this because, I have installed 200+ links a few years ago.

On Tue, Sep 14, 2010 at 11:49 PM, Abiola Jewoola <biola_y2k_at_yahoo.com>wrote:

> The radio is actuall a radwin unlicensed radio.with an E1 interface.
>
> I dont knw if u any idea abt the default e1 settings for this radio.
>
> --- On *Tue, 9/14/10, Radioactive Frog <pbhatkoti_at_gmail.com>* wrote:
>
>
> From: Radioactive Frog <pbhatkoti_at_gmail.com>
> Subject: Re: E1 interface
>
> To: "Abiola Jewoola" <biola_y2k_at_yahoo.com>
> Cc: ccielab_at_groupstudy.com
> Date: Tuesday, September 14, 2010, 6:10 AM
>
>
> Ask radio guy if the provided E1 is framed or unframed.
> If radio output is E1 framed then your config is correct and make sure they
> have timeslot 1-31 in radio. In this instance your E1 controller won't come
> up till you plug-in another router at other side of radio link.
>
> If radio link is E1 unframed, they you can do either config - framed or
> unframed. as long as it matches at both end you should be okay.
>
> BTW which backhaul radio they are using? - i have extensive experience with
> a few teleco grade radio vendor. can guide you if you still searching for
> answer!!
>
> good luck
>
> frog
>
> On Tue, Sep 14, 2010 at 7:48 PM, Abiola Jewoola <biola_y2k@yahoo.com<http://us.mc516.mail.yahoo.com/mc/compose?to=biola_y2k@yahoo.com>
> > wrote:
>
> hello GS
>
> i have a VWIC-1MFT-E1 card installed on a 3700 series router which is to be
> connected to an E1 radio for data traffic . i have done the initial config
> in
> bringing the E1 card up
>
>
> But the E1 interface is still down
>
> controller E1 1/0
> framing crc4
> linecode hdb3
> channel-group 0 timeslots 1-31
> no shut
>
>
> i can see the serial interface when i do sh ip int bri and sh ver
>
> Any ideas as to why d e1 int is down?
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Wed Sep 15 2010 - 17:10:15 ART