RE: Internetwork Expert's R&S Topology

Thanks Bobola. I actually have reviewed and still going over the video
again. It was in there they mentioned to replace with the file that is not
working for me.

Oh well, I'II keep at it since I don't have a choice now.

Thanks.

-----Original Message-----
From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
Bobola Oke
Sent: Sunday, September 12, 2010 3:42 PM
To: Babatunde Sanda
Cc: Segun Daini; Cisco certification
Subject: Re: Internetwork Expert's R&S Topology

Meen Tunde, sorry o....
the 7200 and 7201 are used as well as udp ports for communication among the
virtual devices check this out:

http://classroom.internetworkexpert.com/p27794135/

best of luck

On 9/12/10, Babatunde Sanda <sbabatunde1_at_ca.rr.com> wrote:
> Thanks for the hint Segun but aren't the 7200 & 7201 the ports being used?
> Or are you referring to something else in the install?
>
> Thanks.
>
> Babatunde Sanda
> :: Sent from my Iphone. Apologies for errors and brevity. ::
>
> On Sep 11, 2010, at 10:25 PM, Segun Daini <segundaini_at_gmail.com> wrote:
>
>> Hi Tunde,
>>
>> What is ur base udp port? The default is 10000. Change that value. My
>> guess is you've got another process using that port.
>>
>> Regards.
>>
>> On 11 Sep 2010 23:45, "Babatunde Sanda" <sbabatunde1_at_ca.rr.com> wrote:
>>
>> A little help with dynamips guys. So I have followed the videos and
>> have successfully installed needed programs. But when I click
>> Dynamips server the session comes up and then disappears. If I edit
>> it with notepad I see this
>>
>> @echo off
>> rem Launch a local copy of dynamips
>> start /belownormal /min "Dynamips" "dynamips.exe" -H 7200 start
>> /belownormal /min "Dynamips" "dynamips.exe" -H 7201
>>
>> I am trying to make it work in Windows 7. Is there something am missing.
>>
>>
>> If I don't change the "dynamips-start.cmd" as stated in the tutorial
>> video the dynamips server loads. But below is what is in the file
>>
>> @echo off
>> rem Launch a local copy of dynamips
>> set dynamips=%CD%\dynamips.exe
>> cd %TEMP%
>> start /belownormal "Dynamips" cmd /c ""%dynamips%" -H 7200 & pause"
>>
>>
>> Any hint appreciated. Still trying but getting nowhere so far.
>>
>>
>>
>>
>>
>> -----Original Message-----
>> From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf ...
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _____________________________________________________________________
>> __ Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> ______________________________________________________________________
> _ Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

--
Bobola Oke
Blogs and organic groups at http://www.ccie.net