Re: ospf issue

Hi,

From the explanation there is no single point that is indicating the
conflict.
As the OSPF process number for ipv4 on multiple router doesn't matter in
forming the adjacency.

Thanks,
Dara

On Tue, Sep 29, 2009 at 10:58 PM, Nathan Richie <nathanr_at_boice.net> wrote:

> Can you post your configs?
>
> -----Original Message-----
> From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of
> aashish kapoor
> Sent: Tuesday, September 29, 2009 12:14 PM
> To: Rick Mur
> Cc: Divin Mathew John; ccielab_at_groupstudy.com
> Subject: Re: ospf issue
>
> Hi Rick,
>
> I have not erased the configuration before rebooting it.
> Further i am geting error
> %OSPF: OSPF not enabled on Serial1
> wherein I have ip address of the interface in the network statement and in
> the interface level command i have entered command
> ip ospf network point-to-point
> still i am geting the same error
>
>
>
> On Tue, Sep 29, 2009 at 9:03 PM, Rick Mur <rmur_at_ipexpert.com> wrote:
>
> > If you ping the other end, no packet loss?
> > What kind of link is between the 2 routers?
> > Could you post the OSPF and interface configuration of both routers.
> >
> > Have you erased the configs of both routers and reloaded them both and
> then
> > reconfigured this?
> >
> > --
> >
> > Regards,
> >
> > Rick Mur
> > CCIE2 #21946 (R&S / Service Provider)
> > Sr. Support Engineer IPexpert, Inc.
> > URL: http://www.IPexpert.com <http://www.ipexpert.com/>
> >
> >
> > On Tue, Sep 29, 2009 at 4:50 PM, aashish kapoor <
> operationccie_at_gmail.com
> > > wrote:
> >
> >> Thanks but I have checked all of them they were fine
> >> I have just got the same network statement in the new process and it is
> >> working
> >>
> >> Regards
> >> Aashish Kapoor
> >>
> >> On Tue, Sep 29, 2009 at 8:13 PM, Divin Mathew John <divinjohn_at_gmail.com
> >> >wrote:
> >>
> >> > Check the following
> >> >
> >> > 1) Area configured on both sides shud match
> >> > 2) Stub flag shud match
> >> > 3) Timers shud Match
> >> > 4) Dr/BDR Election type shud match
> >> > 5) MTU shud Match
> >> >
> >> >
> >> > On Tue, Sep 29, 2009 at 8:04 PM, aashish kapoor <
> >> operationccie_at_gmail.com
> >> > > wrote:
> >> >
> >> >> Hi Group,
> >> >>
> >> >> I have faced one issue with ospf.
> >> >> R1 ------ R2
> >> >> running point to point ospf were not forming ospf adjacency
> >> >> I have checked every possible cause and turned debug on only message
> is
> >> >> got
> >> >> was that the far end in dead
> >> >> I have restarted ospf process..... have remove and added the network
> >> >> statement again but it did not worked.
> >> >>
> >> >> Then I have removed network statement from the existing ospf process
> >> and
> >> >> created a new ospf process and added this statement into it. It
> worked
> >> and
> >> >> formed adjacency.
> >> >>
> >> >> Please advise what could be possible cause.
> >> >>
> >> >> Regards
> >> >> Aashish Kapoor
> >> >>
> >> >>
> >> >> Blogs and organic groups at http://www.ccie.net
> >> >>
> >> >>
> _______________________________________________________________________
> >> >> Subscription information may be found at:
> >> >> http://www.groupstudy.com/list/CCIELab.html
> >> >>
> >> >>
> >> >>
> >> >>
> >> >>
> >> >>
> >> >>
> >> >>
> >> >
> >> >
> >> > --
> >> >
> >> > Sent from Karnataka, India
> >> > Vilhjalmur Stefansson <http://www.quotationspage.com/quote/1459.html>
> >> -
> >> > "What is the difference between unethical and ethical advertising?
> >> Unethical
> >> > advertising uses...
> >>
> >>
> >> Blogs and organic groups at http://www.ccie.net
> >>
> >> _______________________________________________________________________
> >> Subscription information may be found at:
> >> http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Wed Sep 30 2009 - 02:13:37 ART