Re: BGP dampening parameters

Hi Joe,

  Thanks for the response.As you mentioned tried again after quite long time
still the same.I am sure missing something and now I am understanding from
your response that the o/p should be displayed even using route-map right ?
....I am using IOS version 12.4(10c) advance enterprise fetaure
set,hopefully thats not the issue.

Thank You for the help Joe

Regards
Anantha Subramanian Natarajan

On Wed, Sep 23, 2009 at 2:00 AM, Joe Astorino <jastorino_at_ipexpert.com>wrote:

> Give it a few minutes and try the command again : ) Sometimes it takes a
> bit of time to apply
>
> On Wed, Sep 23, 2009 at 12:18 AM, Anantha Subramanian Natarajan <
> anantha.natarajan_at_gravitant.com> wrote:
>
>> Hi All,
>>
>> Whenever I set the bgp dampening parameters under the bgp process, I
>> could
>> see the parameters set by issuing the "show ip bgp dampening parameters"
>> command , but when I set the bgp dampening parameters based on a
>> route-map,I
>> get this message "% dampening reconfiguration in progress for IPv4
>> Unicast"
>> when issued the "show ip bgp dampening parameters".Is that a expected o/p
>> .Kindly let me know your inputs.
>>
>> Thanks for the assistance
>>
>> Regards
>> Anantha Subtramanian Natarajan
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html
>>
>>
>>
>>
>>
>>
>>
>>
>
>
> --
> Regards,
>
> Joe Astorino - CCIE #24347 R&S
> Technical Instructor - IPexpert, Inc.
> Cell: +1.586.212.6107
> Fax: +1.810.454.0130
> Mailto: jastorino_at_ipexpert.com

Blogs and organic groups at http://www.ccie.net
Received on Wed Sep 23 2009 - 06:52:36 ART