Interface in multiple OSPF prcesses having multiple areas?

Experts,

Can an ospf interface participate in more than one process having multiple area?

I tried to do do this, strange output... see "sh ip ospf int br" output where it says PID =3 /AREA=2 but i configured ID=3/AREA=0

In think answer is no? Any comments....

Ta,

-----------------------------------
NEW#
NEW#
NEW#
NEW#s
Sep 9 23:06:11.466: %SYS-5-CONFIG_I: Configured from console by console
NEW#sro
router ospf 1
 log-adjacency-changes
 network 1.1.1.1 0.0.0.0 area 1
router ospf 2
 router-id 1.1.1.2
 log-adjacency-changes
 network 1.1.1.1 0.0.0.0 area 2
router ospf 3
 router-id 1.1.1.3
 log-adjacency-changes
 network 1.1.1.1 0.0.0.0 area 0
alias exec sro show running-config | section router ospf
NEW#
NEW#
NEW#

NEW#sh ip int brie
Interface IP-Address OK? Method Status Protocol
FastEthernet0/1 1.1.1.1 YES manual up up
NEW#
NEW#

NEW#sh ip ospf int f0/1
FastEthernet0/1 is up, line protocol is up
  Internet Address 1.1.1.1/24, Area 2
  Process ID 3, Router ID 1.1.1.3, Network Type BROADCAST, Cost: 1
  Enabled by interface config, including secondary ip addresses
  Transmit Delay is 1 sec, State DR, Priority 1
  Designated Router (ID) 1.1.1.3, Interface address 1.1.1.1
  No backup designated router on this network
  Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
    oob-resync timeout 40
    Hello due in 00:00:05
  Supports Link-local Signaling (LLS)
  Index 1/1, flood queue length 0
  Next 0x0(0)/0x0(0)
  Last flood scan length is 0, maximum is 0
  Last flood scan time is 0 msec, maximum is 0 msec
  Neighbor Count is 0, Adjacent neighbor count is 0
  Suppress hello for 0 neighbor(s)

NEW#
NEW#
NEW#
NEW#
NEW#sh ip osfp int br
Interface PID Area IP Address/Mask Cost State Nbrs F/C
Fa0/1 3 2 1.1.1.1/24 1 DR 0/0
NEW#
NEW#
---------------------------------------------------------------------

Blogs and organic groups at http://www.ccie.net
Received on Wed Sep 09 2009 - 22:12:43 ART