Re: Synchronous and ASynchronous

To add a little and as you try this, .. do a show interface and check which
signals are up. There are some commands to ignore or change the physical
characteristics for these cards ... give these a try. Might be needed ...

If you want to copy and paste the output, feel free to respond with this.

Here is a link that might help ...
http://www.cisco.com/en/US/docs/routers/access/3200/software/wired/M517modm.pdf

HTH,

Andrew Lee Lissitz

On Sat, Jun 6, 2009 at 11:13 AM, GAURAV MADAN <gauravmadan1177_at_gmail.com>wrote:

> AFAIK .. WIC-1t / 2t can operate in sync as well as async modes .
> Try command
>
> interface serial <>
> physical-layer async
>
> Best Regards
> Gaurav Madan
>
> On Sat, Jun 6, 2009 at 2:57 PM, R.B. Kumar <seekumarin_at_gmail.com> wrote:
>
> > Hi,
> >
> > I want to is this possible to connect Synchronous Serial interface
> (WIC-1T)
> > to an external CDMA Modem with RS-232 port (9pin). Or do i need
> > Asynchronous
> > serial interface (WIC-2A/S). Can you please explain how it works in this
> > scenario?
> >
> > R.B.KUMAR
> >
> >
> > Blogs and organic groups at http://www.ccie.net
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>

-- 
Andrew Lee Lissitz
all.from.nj_at_gmail.com
Blogs and organic groups at http://www.ccie.net