ip multicast rate-limit command

From: ENVULADU TSAKU (tenvuladu@gmail.com)
Date: Wed Jan 28 2009 - 10:00:56 ARST

Next message: Antonio Soares: "SPA-IPSEC-2G"
Previous message: Bogdan Sass: "Re: BGP full-mesh"
Next in thread: Jared Scrivener: "RE: ip multicast rate-limit command"
Maybe reply: Jared Scrivener: "RE: ip multicast rate-limit command"
Maybe reply: Hobbs: "Re: ip multicast rate-limit command"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi all,

I am a little confused with the directions on this command.The DocCD says it
is used to

*To control the rate a sender from the source list can send to a multicast
group in the group list, use the ip multicast rate-limit command in
interface configuration mode

*This means if i have a scenario
source-----fa0/0 R1 fa0/1 -------------------fa0/1 R2
fa0/1-------------Group-members.

if i am to limit bandwidth on R1 fa0/0 to the multicast group members,will
it be IP MULTICAST RATE-LIMIT IN OR IP MULTICAST RATE_LIMIT OUT ?

i feel its in.

Thanks

Blogs and organic groups at http://www.ccie.net

Next message: Antonio Soares: "SPA-IPSEC-2G"
Previous message: Bogdan Sass: "Re: BGP full-mesh"
Next in thread: Jared Scrivener: "RE: ip multicast rate-limit command"
Maybe reply: Jared Scrivener: "RE: ip multicast rate-limit command"
Maybe reply: Hobbs: "Re: ip multicast rate-limit command"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sun Mar 01 2009 - 09:43:40 ARST