From: Piotr (usaccie@gmail.com)
Date: Tue Dec 16 2008 - 02:53:30 ARST
You can use the interface command *ip rip triggered *to send updates only
where there is a topology change.
On Mon, Dec 15, 2008 at 11:29 PM, Scott Morris <
smorris@internetworkexpert.com> wrote:
> Change timers? Summarize?
>
> Ask the proctor? :)
>
>
> Scott Morris, CCIE4 #4713, JNCIE-M #153, JNCIS-ER, CISSP, et al.
> CCSI/JNCI-M/JNCI-ER
> Senior CCIE Instructor
>
> smorris@internetworkexpert.com
>
>
>
> Knowledge is power.
> Power corrupts.
> Study hard and be Eeeeviiiil......
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> John
> Edom
> Sent: Monday, December 15, 2008 10:59 PM
> To: Cisco certification
> Subject: RIP minimize updates
>
> hi,
>
> scanerio is like below, R1 and R2 are running RIP in a and vlan network is
> 192.168.1.0/24. R2 and R3 are running ospf in seperate vlan and net is
> 10.1.1.0/24.
>
> R1--------R2----------R3
>
> If question ask to minimize update traffic on R2 what it means ? We can
> you
> default passive and then no passive for interface that is connected with R1
> but since R2-R3 are on different network and i will configure command
> "network 192.168.1.0" so it will not send updates on other interface.
> There could be other solution that send update as unicast but i need your
> comments on it.
>
> Regards
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Thu Jan 01 2009 - 12:53:08 ARST