high rxloads

From: Haroon (itguy.pro@gmail.com)
Date: Wed Nov 26 2008 - 15:16:22 ARST

• Next message: Chuck Ryan (chryan): "Configuring logging level on a switch"
• Previous message: Marko Milivojevic: "Re: iBGP RR Cluster ID - What is best practice?"
• Next in thread: ron.wilkerson@gmail.com: "Re: high rxloads"
• Maybe reply: ron.wilkerson@gmail.com: "Re: high rxloads"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello Experts,

What are some of the reasons for this output when you do show int:

SATL-RCore#show int s0/2/0
Serial0/2/0 is up, line protocol is up
  Hardware is GT96K with integrated T1 CSU/DSU
  Description: connected to Internet
  Internet address is ip.address/30
  MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
   * reliability 255/255, txload 29/255, rxload 175/255*

The reliability line in particular.... I've tried using nbar and ip
accounting to figure out where the traffic is coming from but have not been
successful so far.

Thanks,

Haroon

Blogs and organic groups at http://www.ccie.net

• Next message: Chuck Ryan (chryan): "Configuring logging level on a switch"
• Previous message: Marko Milivojevic: "Re: iBGP RR Cluster ID - What is best practice?"
• Next in thread: ron.wilkerson@gmail.com: "Re: high rxloads"
• Maybe reply: ron.wilkerson@gmail.com: "Re: high rxloads"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Mon Dec 01 2008 - 08:18:32 ARST