Question about Initial Config in the LAB

From: Reza Toghraee (reza@toghraee.com)
Date: Sun Oct 12 2008 - 11:50:34 ART

• Next message: Jared Scrivener: "RE: Question about Initial Config in the LAB"
• Previous message: jockey wearer: "Re: Voice:Cisco IP Phone 7911 transfer call issue."
• Next in thread: Jared Scrivener: "RE: Question about Initial Config in the LAB"
• Maybe reply: Jared Scrivener: "RE: Question about Initial Config in the LAB"
• Maybe reply: Jason Madsen: "Re: Question about Initial Config in the LAB"
• Maybe reply: Asif: "Re: Question about Initial Config in the LAB"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hello.

My question is about initial configuration.

Is it a MUST to check the initial configuration and compare it to the
diagram even if they didn't mentioned about faults in initial config?

Do we have right to change or correct the initial config according to the
topology?

Thanks

Reza Toghraee

Blogs and organic groups at http://www.ccie.net

• Next message: Jared Scrivener: "RE: Question about Initial Config in the LAB"
• Previous message: jockey wearer: "Re: Voice:Cisco IP Phone 7911 transfer call issue."
• Next in thread: Jared Scrivener: "RE: Question about Initial Config in the LAB"
• Maybe reply: Jared Scrivener: "RE: Question about Initial Config in the LAB"
• Maybe reply: Jason Madsen: "Re: Question about Initial Config in the LAB"
• Maybe reply: Asif: "Re: Question about Initial Config in the LAB"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Sat Nov 01 2008 - 15:35:20 ARST