From: Darby Weaver (ccie.weaver@gmail.com)
Date: Sat Sep 27 2008 - 19:31:43 ART
A few things that you might consider:
1. Where is this line:
%FABRIC-SP-5-FABRIC_MODULE_ACTIVE: The Switch Fabric Module in slot 5
became active.
2. What IOS Version do you have on yuor supervisor? Have you checked it for
any issues or bugs? Was it upgraded recently? Why?
3. Have you consulted TAC?
4. Have you considered configured the supervisor to offload the crashdump to
an FTP server so you'll have something tangible for TAC?
5. Have you prepared a show tech-support for TAC to analyze?
6. Are there any other events surrounding this issue and exactly how many
time and how often is it happening?
7. Have you checked the flash for any crash_dump information?
Let me know if I can be of further assistance.
Darby Weaver
Just some ideas off the top.
On Sat, Sep 27, 2008 at 5:30 PM, john matijevic <john.matijevic@gmail.com>wrote:
> Hello,
> Try replacing the Sup modules.
> Sincerely,
> John
>
> On Sat, Sep 27, 2008 at 3:38 AM, Mister T <romantic24hrs@gmail.com> wrote:
>
> > Dear expert,
> >
> > I have problem experiencing partial network outages in my one Catalyst
> > 6509-E. It happens many times in almost 2 months, and when it happens
> > partial network outage takes about 10 minutes (LAN and WAN traffic down).
> >
> > I have a suspect that something is not right for the dual supervisor
> > redundancy (when doing switchover). I also noticed that the standby Sup
> in
> > slot 6 shows 'Minor Error'. I went to the 'Error Message Decoder' at
> > cisco.com to interpret the error messages from the log, but it says: no
> > action is required. For details i enclose the log from the switch.
> >
> > ------------------ show module ------------------
> >
> >
> > Mod Ports Card Type Model
> Serial
> > No.
> > --- ----- -------------------------------------- ------------------
> > -----------
> > 2 16 SFM-capable 16 port 1000mb GBIC WS-X6516-GBIC -
> > 3 16 SFM-capable 16 port 1000mb GBIC WS-X6516-GBIC -
> > 4 16 SFM-capable 16 port 1000mb GBIC WS-X6516A-GBIC -
> > 5 2 Supervisor Engine 720 (Active) WS-SUP720-3B -
> > 6 2 Supervisor Engine 720 (Hot) WS-SUP720-3B -
> > 7 16 SFM-capable 16 port 10/100/1000mb RJ45 WS-X6516-GE-TX -
> > 8 48 SFM-capable 48 port 10/100/1000mb RJ45 WS-X6548-GE-TX -
> >
> > Mod MAC addresses Hw Fw Sw
> > Status
> > --- ---------------------------------- ------ ------------ ------------
> > -------
> > 2 0001.6463.0df8 to 0001.6463.0e07 4.4 7.2(1) 8.5(0.46)RFW Ok
> > 3 0009.11e3.05a4 to 0009.11e3.05b3 5.0 6.3(1) 8.5(0.46)RFW Ok
> > 4 0019.aa98.6a20 to 0019.aa98.6a2f 4.5 7.2(1) 8.5(0.46)RFW Ok
> > 5 0014.a982.4ba0 to 0014.a982.4ba3 5.2 8.4(2) 12.2(18)SXF9 Ok
> > 6 0017.9441.c344 to 0017.9441.c347 5.2 8.4(2) 12.2(18)SXF9 Ok
> > 7 001a.6d87.0cf0 to 001a.6d87.0cff 2.8 6.3(1) 8.5(0.46)RFW Ok
> > 8 0009.7c46.ee4a to 0009.7c46.ee79 10.1 7.2(1) 8.5(0.46)RFW Ok
> >
> > Mod Sub-Module Model Serial Hw
> > Status
> > ---- --------------------------- ------------------ ----------- -------
> > -------
> > 5 Policy Feature Card 3 WS-F6K-PFC3B - 2.3
> Ok
> > 5 MSFC3 Daughterboard WS-SUP720 - 2.5 Ok
> > 6 Policy Feature Card 3 WS-F6K-PFC3B - 2.3 Ok
> > 6 MSFC3 Daughterboard WS-SUP720 - 2.5 Ok
> >
> > Mod Online Diag Status
> > ---- -------------------
> > 2 Pass
> > 3 Pass
> > 4 Pass
> > 5 Pass
> > 6 Minor Error
> > 7 Pass
> > 8 Pass
> >
> >
> > ***************************************************
> > ****** Information of Last System Crash - SP ******
> > ***************************************************
> >
> >
> > Using sup-bootflash:crashinfo_20080915-101604.
> >
> > Writing crashinfo to bootflash:crashinfo_20080915-101604ot 6, interfaces
> > are
> > now online
> >
> > Sep 15 17:02:34.005 WIB: %PFREDUN-SP-6-ACTIVE: Standby initializing for
> SSO
> > mode
> > Sep 15 17:02:34.005 WIB: %SYS-SP-3-LOGGER_FLUSHING: System pausing to
> > ensure
> > console debugging output.
> >
> > Sep 15 17:02:34.005 WIB: %PFREDUN-SP-6-ACTIVE: Standby initializing for
> SSO
> > mode
> > Sep 15 17:02:34.201 WIB: %SYS-SP-3-LOGGER_FLUSHED: System was paused for
> > 00:00:00 to ensure console debugging output.
> >
> > Sep 15 17:02:35.525 WIB: %PFINIT-SP-5-CONFIG_SYNC: Sync'ing the startup
> > configuration to the standby Router.
> > Sep 15 17:03:15.510 WIB: %FABRIC-SP-5-CLEAR_BLOCK: Clear block option is
> > off
> > for the fabric in slot 6.
> > Sep 15 17:03:15.606 WIB: %FABRIC-SP-5-FABRIC_MODULE_BACKUP: The Switch
> > Fabric Module in slot 6 became standby
> > Sep 15 17:03:16.434 WIB: %DIAG-SP-6-RUN_MINIMUM: Module 6: Running
> Minimal
> > Diagnostics...
> > Sep 15 17:03:17.874 WIB: %DIAG-SP-6-DIAG_OK: Module 6: Passed Online
> > Diagnostics
> > Sep 15 17:03:18.114 WIB: %OIR-SP-6-INSCARD: Card inserted in slot 6,
> > interfaces are now online
> > Sep 15 17:07:55.371 WIB: %PFREDUN-SP-6-ACTIVE: Standby processor removed
> or
> > reloaded, changing to Simplex mode
> > Sep 15 17:10:07.419 WIB: %PFREDUN-SP-6-ACTIVE: Standby initializing for
> SSO
> > mode
> > Sep 15 17:10:07.419 WIB: %SYS-SP-3-LOGGER_FLUSHING: System pausing to
> > ensure
> > console debugging output.
> >
> > Sep 15 17:10:07.419 WIB: %PFREDUN-SP-6-ACTIVE: Standby initializing for
> SSO
> > mode
> > Sep 15 17:10:07.611 WIB: %SYS-SP-3-LOGGER_FLUSHED: System was paused for
> > 00:00:00 to ensure console debugging output.
> >
> > Sep 15 17:10:09.644 WIB: %PFINIT-SP-5-CONFIG_SYNC: Sync'ing the startup
> > configuration to the standby Router.
> > Sep 15 17:10:50.140 WIB: %FABRIC-SP-5-CLEAR_BLOCK: Clear block option is
> > off
> > for the fabric in slot 6.
> > Sep 15 17:10:50.232 WIB: %FABRIC-SP-5-FABRIC_MODULE_BACKUP: The Switch
> > Fabric Module in slot 6 became standby
> > Sep 15 17:10:51.560 WIB: %DIAG-SP-6-RUN_MINIMUM: Module 6: Running
> Minimal
> > Diagnostics...
> > Sep 15 17:10:53.020 WIB: %DIAG-SP-6-DIAG_OK: Module 6: Passed Online
> > Diagnostics
> > Sep 15 17:10:53.216 WIB: %OIR-SP-6-INSCARD: Card inserted in slot 6,
> > interfaces are now online
> > Sep 15 17:15:30.617 WIB: %PFREDUN-SP-6-ACTIVE: Standby processor removed
> or
> > reloaded, changing to Simplex mode
> >
> >
> > Any help to resolve this problem would be appreciated.
> >
> > Regards
> >
> > mrt
> >
> >
> > Blogs and organic groups at http://www.ccie.net
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> > http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Blogs and organic groups at http://www.ccie.net
This archive was generated by hypermail 2.1.4 : Sat Oct 04 2008 - 09:26:20 ART