RE: TRUNKING

From: Gupta, Gopal (NWCC) (gopal.gupta@hp.com)
Date: Thu Apr 10 2008 - 08:07:54 ART

• Next message: Scott Morris: "RE: RFC 3330 Network Ranges"
• Previous message: Asif: "TRUNKING"
• Maybe in reply to: Asif: "TRUNKING"
• Next in thread: Asif: "Re: TRUNKING"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Hi Asif,

Not needed. Lab it up and you will find it automatically inherit that commands to interface Po25.

HTH
Gops

-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Asif
Sent: Thursday, April 10, 2008 16:31
To: Cisco certification
Subject: TRUNKING
Importance: Low

Hi,

I would like to understand ; if my interface configuration is

interface fa 0/1
switchport trunk encapsulation dot1q
switchport mode trunk
chanel-group 25 mode on

The above creates a port-channel 25,

do I need to add the following to the port-channel 25 based on my
interface config,

Interface port-channel 25
switchport trunk encapsulation dot1q
switchport mode trunk

Regards
Asif

Pass the CCIE in six weeks, Guaranteed!
http://www.certscience.com/CCIE

• Next message: Scott Morris: "RE: RFC 3330 Network Ranges"
• Previous message: Asif: "TRUNKING"
• Maybe in reply to: Asif: "TRUNKING"
• Next in thread: Asif: "Re: TRUNKING"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu May 01 2008 - 08:25:50 ART