From: Asif (asif@vanoo.com)
Date: Thu Apr 10 2008 - 09:03:23 ART
Hi Gopal,
I would like to thank you for your reply, but when see the configuration
of the switch under port-channel 25 ; it doesnt shows me the two statements
( switchport trunk encapsulation dot1q / switchport mode trunk )
Interface port-channel 25 ( its up )
Sh EtherChannel shows output as ( SD )
Regards
Asif
Gupta, Gopal (NWCC) wrote:
> Hi Asif,
>
> Not needed. Lab it up and you will find it automatically inherit that commands to interface Po25.
>
> HTH
> Gops
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Asif
> Sent: Thursday, April 10, 2008 16:31
> To: Cisco certification
> Subject: TRUNKING
> Importance: Low
>
> Hi,
>
> I would like to understand ; if my interface configuration is
>
> interface fa 0/1
> switchport trunk encapsulation dot1q
> switchport mode trunk
> chanel-group 25 mode on
>
> The above creates a port-channel 25,
>
> do I need to add the following to the port-channel 25 based on my
> interface config,
>
> Interface port-channel 25
> switchport trunk encapsulation dot1q
> switchport mode trunk
>
> Regards
> Asif
>
>
> Pass the CCIE in six weeks, Guaranteed!
> http://www.certscience.com/CCIE
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
> Pass the CCIE in six weeks, Guaranteed!
> http://www.certscience.com/CCIE
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
Pass the CCIE in six weeks, Guaranteed!
http://www.certscience.com/CCIE
This archive was generated by hypermail 2.1.4 : Thu May 01 2008 - 08:25:50 ART