From: Moses Polalysa (mpurple7@yahoo.com)
Date: Wed Mar 26 2008 - 10:43:30 ART
Hi,
Thanks for the reply. I have tried again but it also not working.
SW1(config-if)#exit
SW1(config)#int vlan 10
SW1(config-if)#service-policy output VLAN
Match input interface is not supported for this interface
SW1(config-if)#
Basically, I want to mark traffic from, let's say, VLAN 50 in Gi1/0/24 with ip precedence 5.
Regards,
Moses
----- Original Message ----
From: Gabriel Nunes <gabriel.nunes@gmail.com>
To: Moses Polalysa <mpurple7@yahoo.com>
Cc: ccielab@groupstudy.com
Sent: Wednesday, March 26, 2008 8:36:29 PM
Subject: Re: Apply MQC in switchport
the vlan-based command should be applied on layer 2 interface and service-policy on SVI interface
On Wed, Mar 26, 2008 at 10:26 AM, Moses Polalysa <mpurple7@yahoo.com> wrote:
Hi,
Thanks for your reply. I have tried but still not work out. :(
SW1(config-if)#mls qos vlan-based
SW1(config-if)#service-policy out VLAN_A
Match input interface is not supported for this interface
SW1(config-if)#
Regards,
Moses
----- Original Message ----
From: Gabriel Nunes <gabriel.nunes@gmail.com>
To: Sadiq Yakasai <sadiqtanko@gmail.com>
Cc: Moses Polalysa <mpurple7@yahoo.com>; ccielab@groupstudy.com
Sent: Wednesday, March 26, 2008 7:33:28 PM
Subject: Re: Apply MQC in switchport
I think you must configure "mls qos vlan-based" on switchport interface and so configure the service-policy on SVI interface.
Gabriel
On Wed, Mar 26, 2008 at 7:50 AM, Sadiq Yakasai <sadiqtanko@gmail.com> wrote:
Hi Moses,
Not all platforms support marking traffic in all directions actually.
And my guess is you are experiencing this behaviour on the 3560.
Try going through the documentation and seeing if egress marking is
supported on the 3560. Else, you could change your concept and mark on
the ingress anyway.
HTH
Sadiq
This archive was generated by hypermail 2.1.4 : Tue Apr 01 2008 - 07:53:54 ART