From: Gabriel Nunes (gabriel.nunes@gmail.com)
Date: Wed Mar 26 2008 - 10:36:29 ART
the vlan-based command should be applied on layer 2 interface and
service-policy on SVI interface
On Wed, Mar 26, 2008 at 10:26 AM, Moses Polalysa <mpurple7@yahoo.com> wrote:
> Hi,
>
> Thanks for your reply. I have tried but still not work out. :(
>
> SW1(config-if)#mls qos vlan-based
> SW1(config-if)#service-policy out VLAN_A
> Match input interface is not supported for this interface
> SW1(config-if)#
>
> Regards,
> Moses
>
>
>
> ----- Original Message ----
> From: Gabriel Nunes <gabriel.nunes@gmail.com>
> To: Sadiq Yakasai <sadiqtanko@gmail.com>
> Cc: Moses Polalysa <mpurple7@yahoo.com>; ccielab@groupstudy.com
> Sent: Wednesday, March 26, 2008 7:33:28 PM
> Subject: Re: Apply MQC in switchport
>
> I think you must configure "mls qos vlan-based" on switchport interface
> and so configure the service-policy on SVI interface.
>
> Gabriel
>
>
> On Wed, Mar 26, 2008 at 7:50 AM, Sadiq Yakasai <sadiqtanko@gmail.com>
> wrote:
> Hi Moses,
>
> Not all platforms support marking traffic in all directions actually.
> And my guess is you are experiencing this behaviour on the 3560.
>
> Try going through the documentation and seeing if egress marking is
> supported on the 3560. Else, you could change your concept and mark on
> the ingress anyway.
>
> HTH
>
> Sadiq
>
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>
>
>
>
>
> ____________________________________________________________________________________
> Be a better friend, newshound, and
> know-it-all with Yahoo! Mobile. Try it now.
> http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Tue Apr 01 2008 - 07:53:54 ART