From: Antonio Soares (amsoares@netcabo.pt)
Date: Sun Feb 10 2008 - 09:05:14 ARST
You need to define an ATM switch in Dynamips:
################
# ATM SWITCH-1 #
################
[[ATMSW ATMSW-1]]
1:0:102 = 2:0:201
Basic configs:
R1:
interface ATM3/0.1 point-to-point
ip address 12.12.12.1 255.255.255.0
pvc 0/102
R2:
interface ATM3/0.1 point-to-point
ip address 12.12.12.2 255.255.255.0
pvc 0/201
Regards,
Antonio Soares
CCIE #18473 (R&S),CCNP,CCIP,JNCIA-ER,JNCIS-ER
http://pwp.netcabo.pt/amsoares/
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
backbone systems
Sent: domingo, 10 de Fevereiro de 2008 6:05
To: Cisco certification
Cc: Cisco certification
Subject: Dynamips ATM Back to Back Config
Hi,
I am using Dynamips for ATM PA-A1 for back to back configuration.
Can someone send me the basic config for the two routers connected back to
back.
It is the first time i am handling the ATM interfaces .
Please send me the basic config to enable ping.
BB
This archive was generated by hypermail 2.1.4 : Sat Mar 01 2008 - 16:54:48 ARST