From: Scott Morris (smorris@ipexpert.com)
Date: Thu Jan 10 2008 - 12:05:55 ARST
If you do a debug ip packet on the R2 side, do you see packets going out?
Do you have a route on R2 to 192.168.4.2?
Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, JNCIE-M
#153, JNCIS-ER, CISSP, et al.
CCSI/JNCI-M/JNCI-ER
VP - Technical Training - IPexpert, Inc.
IPexpert Sr. Technical Instructor
A Cisco Learning Partner - We Accept Learning Credits!
Telephone: +1.810.326.1444
Fax: +1.810.454.0130
http://www.ipexpert.com
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
wim.depauw@getronics.com
Sent: Wednesday, January 09, 2008 3:24 PM
To: ccielab@groupstudy.com
Subject: Auto-install over Frame-relay
Hi,
I tried to configure auto-install over Frame-relay but it doesn't seem to
work My setup is the following :
TFTP(pc)-------R1-----FR-----R2
R1 and R2 are connect back to back , R1 has the DCE connector
R2 will need to get his config from R1
interface Serial0/3/0.1 point-to-point
ip address 192.168.2.1 255.255.255.252
ip helper-address 192.168.4.2
frame-relay interface-dlci 101 protocol ip 192.168.2.2 end
I don't see any packets coming in to the tftp -server ( sniffed it ).
According to cisco doc this should be the config .
Does anybody have an idea ?
gr
wim
This archive was generated by hypermail 2.1.4 : Fri Feb 01 2008 - 10:37:58 ARST