From: Tony Blanco (blancoj17@yahoo.com)
Date: Sat Nov 10 2007 - 01:40:43 ART
Team,
I just got a 2620 router...with the latest enterprise ios and the issue that I noticed was that ipv6 is available at the global....but when you go to the interface OSPF is not available...see below, any workaround...any immage that will fully support ipv6.....any suggestions here.....
Thanks,
Rack1R1(config-if)#
Rack1R1(config-if)#ipv6 ?
IPv6 interface subcommands:
address Configure IPv6 address on interface
cef Cisco Express Forwarding for IPv6
enable Enable IPv6 on interface
mtu Set IPv6 Maximum Transmission Unit
nat Enable IPv6 NAT on interface
nd IPv6 interface Neighbor Discovery subcommands
redirects Enable sending of ICMP Redirect messages
rip Configure RIP routing protocol
router IPv6 Router interface commands
traffic-filter Access control list for packets
unnumbered Preferred interface for source address selection
verify Enable per packet validation
Rack1R1(config-if)#ipv6
Rack1R1(config)#ipv6 router ?
ospf Open Shortest Path First (OSPF)
rip IPv6 Routing Information Protocol (RIPv6)
Rack1R1(config)#ipv6 router ospf ?
<1-65535> Process ID
Rack1R1(config)#ipv6 router ospf 17
Rack1R1(config)#
Rack1R1(config)#
Rack1R1#
Rack1R1#show version
Cisco Internetwork Operating System Software
IOS (tm) C2600 Software (C2600-J1S3-M), Version 12.3(24), RELEASE SOFTWARE (fc4)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by cisco Systems, Inc.
Compiled Thu 18-Oct-07 14:27 by stshen
Image text-base: 0x80008098, data-base: 0x81A4D818
ROM: System Bootstrap, Version 12.2(6r), RELEASE SOFTWARE (fc1)
Rack1R1 uptime is 17 minutes
System returned to ROM by reload
System image file is "flash:c2600-j1s3-mz.123-24.bin"
cisco 2620 (MPC860) processor (revision 0x00) with 61440K/4096K bytes of memory.
Processor board ID JAD060809G2 (3958321504)
M860 processor: part number 0, mask 49
Bridging software.
X.25 software, Version 3.0.0.
TN3270 Emulation software.
1 FastEthernet/IEEE 802.3 interface(s)
2 Serial network interface(s)
32K bytes of non-volatile configuration memory.
16384K bytes of processor board System flash (Read/Write)
Configuration register is 0x2102
Rack1R1#
Rack1R1#
This archive was generated by hypermail 2.1.4 : Sat Dec 01 2007 - 06:37:29 ART