From: Shine Joseph (shinepjoseph@iprimus.com.au)
Date: Sun Oct 21 2007 - 16:46:53 ART
Static RP.
The static RP without the override keyword can be used as a failover over
technique for Auto-RP and BSR.
Regards,
Shine
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
graham@cisco-engineer.com
Sent: Monday, 22 October 2007 3:55 AM
To: 'Joseph Brunner'; 'Cisco certification'
Subject: RE: Static RP / AutoRP
Yeah sorry should add,
There is a Gre between the two routers, its then filtered out via VRFs and
the pix does the final termination, it needs to be that way due to the way
the middle router is actually one device but using controlled VRFs.
Management etc is also done from the middle and there are other reasons.
So Gre end to end not an option.
-----Original Message-----
From: Joseph Brunner [mailto:joe@affirmedsystems.com]
Sent: 21 October 2007 18:00
To: graham@cisco-engineer.com; 'Cisco certification'
Subject: RE: Static RP / AutoRP
Bah! That's easy...
Just gre tunnel THRU the pix... Then your bsr/auto-rp messages will flow
unobstructed.
For giggles I would also try anycast/msdp thru the pix...
-Joe
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
graham@cisco-engineer.com
Sent: Sunday, October 21, 2007 12:45 PM
To: 'Cisco certification'
Subject: OT: Static RP / AutoRP
Group,
Slitghly off topic, but here goes
Imagine the scenario, two links, with two routers, primary link router is
defined as the RP. Secondary needs manually brought out of shudown on
failure of primary link or router, you think Auto-RP or BSR right ? well the
problem is the each link goes through a Pix 515e then they both join up at a
6509. In their wisdom pixos 7.0 beyond dropped support for Auto RP or BSR!
Any other suggestions how to avoid the manual failover technique?
Route(RP)------------------Router---PIX------| 6509|
|
| ------ Client
Router(Backup)-----------Router---PIX------| 6509|
Thanks in advance
This archive was generated by hypermail 2.1.4 : Fri Nov 16 2007 - 13:11:17 ART