From: Joseph Brunner (joe@affirmedsystems.com)
Date: Sun Oct 21 2007 - 14:00:16 ART
Bah! That's easy...
Just gre tunnel THRU the pix... Then your bsr/auto-rp messages will flow
unobstructed.
For giggles I would also try anycast/msdp thru the pix...
-Joe
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
graham@cisco-engineer.com
Sent: Sunday, October 21, 2007 12:45 PM
To: 'Cisco certification'
Subject: OT: Static RP / AutoRP
Group,
Slitghly off topic, but here goes
Imagine the scenario, two links, with two routers, primary link router is
defined as the RP. Secondary needs manually brought out of shudown on
failure of primary link or router, you think Auto-RP or BSR right ? well the
problem is the each link goes through a Pix 515e then they both join up at a
6509. In their wisdom pixos 7.0 beyond dropped support for Auto RP or BSR!
Any other suggestions how to avoid the manual failover technique?
Route(RP)------------------Router---PIX------| 6509|
|
| ------ Client
Router(Backup)-----------Router---PIX------| 6509|
Thanks in advance
This archive was generated by hypermail 2.1.4 : Fri Nov 16 2007 - 13:11:17 ART