From: Usankin, Andrew (Andrew.Usankin@twtelecom.com)
Date: Thu Oct 18 2007 - 19:16:38 ART
Yes, you better shut it down with this command:
service-module service-Engine 0/0 shutdown
Andrew
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
WorkerBee
Sent: Thursday, October 18, 2007 3:29 PM
To: Cisco certification
Subject: Cisco AIM-CUE/NM-CUE power off procedure
Since Cisco Unity Express AIM-CUE/NM-CUE contains flash/hard disk, is
there a procedure to properly shutdown the modules before I power off
the router?
I could also do a manual halt the AIM-CUE Linux system before I power
off the router at the end of the training session.
There is an interesting command that display the wear and tear
statistics of the physical flash drive inside the AIM-CUE.
se-192-168-254-101# show interfaces ide 0 IDE hd0 is up, line protocol
is up
4823 reads, 53862400 bytes
0 read errors
1325 write, 15646720 bytes
0 write errors
0.71378% worn
Any feedbacks?
This archive was generated by hypermail 2.1.4 : Fri Nov 16 2007 - 13:11:16 ART