Cisco AIM-CUE/NM-CUE power off procedure

From: WorkerBee (ciscobee@gmail.com)
Date: Thu Oct 18 2007 - 18:28:46 ART

Next message: Melwani, Manoj J : "Take me off the DL list"
Previous message: Jonny English: "Re: just missed again yesterday...2nd time"
Next in thread: Usankin, Andrew: "RE: Cisco AIM-CUE/NM-CUE power off procedure"
Maybe reply: Usankin, Andrew: "RE: Cisco AIM-CUE/NM-CUE power off procedure"
Maybe reply: Mark Snow: "Re: Cisco AIM-CUE/NM-CUE power off procedure"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Since Cisco Unity Express AIM-CUE/NM-CUE contains flash/hard disk, is
there a procedure
to properly shutdown the modules before I power off the router?

I could also do a manual halt the AIM-CUE Linux system before I power
off the router at the end of the training session.

There is an interesting command that display the wear and tear statistics
of the physical flash drive inside the AIM-CUE.

se-192-168-254-101# show interfaces ide 0
IDE hd0 is up, line protocol is up
     4823 reads, 53862400 bytes
     0 read errors
     1325 write, 15646720 bytes
     0 write errors
     0.71378% worn

Any feedbacks?

Next message: Melwani, Manoj J : "Take me off the DL list"
Previous message: Jonny English: "Re: just missed again yesterday...2nd time"
Next in thread: Usankin, Andrew: "RE: Cisco AIM-CUE/NM-CUE power off procedure"
Maybe reply: Usankin, Andrew: "RE: Cisco AIM-CUE/NM-CUE power off procedure"
Maybe reply: Mark Snow: "Re: Cisco AIM-CUE/NM-CUE power off procedure"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Nov 16 2007 - 13:11:16 ART