From: ccie.lab (ccie.lab@verizon.net)
Date: Sun Oct 07 2007 - 02:00:51 ART
Here is what I get, still no vlan.dat after reboot and I erased flash like you
said.
Rack1SW1#vlan d
Rack1SW1(vlan)#vlan 6
VLAN 6 added:
Name: VLAN0006
Rack1SW1(vlan)#exit
APPLY completed.
Exiting....
Rack1SW1#dir
Directory of flash:/
No files in directory
8388604 bytes total (8387880 bytes free)
Rack1SW1#sh fla
System flash directory:
File Length Name/status
1 660 vlan.dat [invalid checksum]
[724 bytes used, 8387880 available, 8388604 total]
8192K bytes of processor board System flash (Read/Write)
Rack1SW1#sh vlan-sw
VLAN Name Status Ports
---- -------------------------------- ---------
-------------------------------
1 default active Fa1/0, Fa1/1, Fa1/2, Fa1/4
Fa1/6, Fa1/8, Fa1/10, Fa1/11
Fa1/12, Fa1/13, Fa1/14
6 VLAN0006 active
1002 fddi-default active
1003 token-ring-default active
1004 fddinet-default active
1005 trnet-default active
----- Original Message -----
From: Sohail Nedaria
To: ccie.lab
Cc: ccielab@groupstudy.com
Sent: Sunday, October 07, 2007 12:48 AM
Subject: Re: Dynamips - cannot save vlan.dat
HI
Try the following command on ur router,
SW1#erase flash
SW1#vlan.dat
SW1# (then try to create ur vlan)
Thanks
Suhail.
On 10/7/07, ccie.lab <ccie.lab@verizon.net> wrote:
I am trying to use the switch module in the dynamips setup with a 3640
router.
However, I cannot get the vlan.dat to save between sessions. I notice
when
the vlan.dat is created it says invalid checksum?
Then it is gone after rebooting Dyanmips?
Please Help!
_______________________________________________________________________
Subscription information may be found at:
http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Nov 16 2007 - 13:11:12 ART