Re: Dynamips - cannot save vlan.dat

From: Sohail Nedaria (sohail.nedaria@gmail.com)
Date: Sun Oct 07 2007 - 01:48:59 ART

• Next message: Scott Morris: "RE: Cisco CCSI Agreement"
• Previous message: ccie.lab: "Dynamips - cannot save vlan.dat"
• Maybe in reply to: ccie.lab: "Dynamips - cannot save vlan.dat"
• Next in thread: ccie.lab: "Re: Dynamips - cannot save vlan.dat"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

HI

            Try the following command on ur router,

SW1#erase flash
SW1#vlan.dat
SW1# (then try to create ur vlan)

Thanks
Suhail.

On 10/7/07, ccie.lab <ccie.lab@verizon.net> wrote:
>
> I am trying to use the switch module in the dynamips setup with a 3640
> router.
> However, I cannot get the vlan.dat to save between sessions. I notice
> when
> the vlan.dat is created it says invalid checksum?
> Then it is gone after rebooting Dyanmips?
>
> Please Help!
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

• Next message: Scott Morris: "RE: Cisco CCSI Agreement"
• Previous message: ccie.lab: "Dynamips - cannot save vlan.dat"
• Maybe in reply to: ccie.lab: "Dynamips - cannot save vlan.dat"
• Next in thread: ccie.lab: "Re: Dynamips - cannot save vlan.dat"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Fri Nov 16 2007 - 13:11:12 ART