From: Shine Joseph (shinepjoseph@iprimus.com.au)
Date: Fri Sep 07 2007 - 15:59:13 ART
Bit,
I got your config working. If I don't add the dialer persistent command in
the dialer interface, the interface is flapping.
R1#
interface Serial0/1
no ip address
dialer in-band
dialer pool-member 1
dialer-group 1
no dce-terminal-timing-enable
pulse-time 1
interface Dialer1
ip address 172.16.31.1 255.255.255.0
dialer pool 1
dialer-group 1
dialer persistent
R3#
interface Serial1/0
no ip address
dialer in-band
dialer pool-member 1
dialer-group 1
clock rate 64000
no dce-terminal-timing-enable
pulse-time 1
interface Dialer1
ip address 172.16.31.3 255.255.255.0
dialer pool 1
dialer-group 1
dialer persistent
R3(config-if)#do ping 172.16.31.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.31.1, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 28/35/60 ms
R1(config-if)#do ping 172.16.31.3
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 172.16.31.3, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 28/33/52 ms
HTH,
Shine
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of Bit
Gossip
Sent: Friday, 7 September 2007 9:04 PM
To: ccielab@groupstudy.com
Subject: serial back-to-back with dialer interface
Experts,
I think this could be possible somehow but I've become quite rusty with DDR
R4 and R5 are connected back-to-back with HDLC encapsulation
That would be nice and easy, but I am not allowed to assign the IP address
directly to the serial interface nor change interface encapsulation.
I was thinking to associate them with a dialer interface and this is as far
as
I could go ....
Please help!
Bit
R5
interface Serial0/1
no ip address
dialer in-band
dialer pool-member 1
clock rate 128000
pulse-time 1
!
interface Dialer1
ip address 145.3.45.5 255.255.255.0
dialer pool 1
dialer-group 1
!
dialer-list 1 protocol ip permit
!
R5#ping 145.3.45.4
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 145.3.45.4, timeout is 2 seconds:
*Mar 1 03:17:21.607: Di1 DDR: Cannot place call, no dialer string set.
This archive was generated by hypermail 2.1.4 : Sat Oct 06 2007 - 12:01:10 ART