From: Mohammed Khasawneh (mohammed.khasawneh@gmail.com)
Date: Thu Jul 05 2007 - 05:14:46 ART
(frame-relay inverse-arp ipv6 ) is not documented under frame-relay
inverse-arp command see
http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cr/hwan_r/wan_f1h.htm#wp1073883
may be it will be used in future .
Regards
----- Original Message -----
From: <brajesh.thakur@wipro.com>
To: <mohammed.khasawneh@gmail.com>; <ccielab@groupstudy.com>
Sent: Thursday, July 05, 2007 10:54 AM
Subject: RE: Frame-relay inverse-arp for IPV6
Thanks mate, I also thought so but my doubt is why do they included the
command "frame-relay inverse-arp ipv6 <dlci>" on interface level.
Warm Regards,
Brajesh Thakur
-----Original Message-----
From: Mohammed Khasawneh [mailto:mohammed.khasawneh@gmail.com]
Sent: Thursday, July 05, 2007 1:21 PM
To: Brajesh Thakur (WI01 - Services); ccielab@groupstudy.com
Subject: Re: Frame-relay inverse-arp for IPV6
Hi Brajesh
Frame-relay dynamic mapping is not support Ipv6
you have to configure the mapping manually !
Regards
----- Original Message -----
From: <brajesh.thakur@wipro.com>
To: <ccielab@groupstudy.com>
Sent: Thursday, July 05, 2007 10:43 AM
Subject: Frame-relay inverse-arp for IPV6
> Dear All,
>
>
>
> I am trying to configure inverse-arp for ipv6 on a frame-relay
circuit,
> but pvc goes into unused state. Its only when I configure static map
> commands pvc comes active.
>
> Configuration:
>
>
>
> Interface serial 1/7
>
> Ipv6 enable
>
> Ipv6 address 2001::/64 eui-64
>
> Encapsulation frame-relay
>
> Frame-relay inverse-arp ipv6 102
>
>
>
> On the same circuit if I am running ipv4 it works quite fine.
>
>
>
> Regards,
>
> Brajesh Thakur
>
>
>
>
>
>
> The information contained in this electronic message and any
attachments
> to
> this message are intended for the exclusive use of the addressee(s)
and
> may
> contain proprietary, confidential or privileged information. If you
are
> not
> the intended recipient, you should not disseminate, distribute or copy
> this
> e-mail. Please notify the sender immediately and destroy all copies of
> this
> message and any attachments.
>
> WARNING: Computer viruses can be transmitted via email. The recipient
> should
> check this email and any attachments for the presence of viruses. The
> company
> accepts no liability for any damage caused by any virus transmitted by
> this
> email.
>
> www.wipro.com
>
>
This archive was generated by hypermail 2.1.4 : Sat Aug 18 2007 - 08:17:39 ART