From: brajesh.thakur@wipro.com
Date: Thu Jul 05 2007 - 04:43:21 ART
Dear All,
I am trying to configure inverse-arp for ipv6 on a frame-relay circuit,
but pvc goes into unused state. Its only when I configure static map
commands pvc comes active.
Configuration:
Interface serial 1/7
Ipv6 enable
Ipv6 address 2001::/64 eui-64
Encapsulation frame-relay
Frame-relay inverse-arp ipv6 102
On the same circuit if I am running ipv4 it works quite fine.
Regards,
Brajesh Thakur
The information contained in this electronic message and any attachments to
this message are intended for the exclusive use of the addressee(s) and may
contain proprietary, confidential or privileged information. If you are not
the intended recipient, you should not disseminate, distribute or copy this
e-mail. Please notify the sender immediately and destroy all copies of this
message and any attachments.
WARNING: Computer viruses can be transmitted via email. The recipient should
check this email and any attachments for the presence of viruses. The company
accepts no liability for any damage caused by any virus transmitted by this
email.
www.wipro.com
This archive was generated by hypermail 2.1.4 : Sat Aug 18 2007 - 08:17:39 ART