From: Andy (and123and@googlemail.com)
Date: Wed Jun 13 2007 - 06:10:31 ART
What is the "best" way to approach the configuring of VLANS section of the
lab?
- Configure vlans on one switch and propagate to all other switches,
assuming trunking is working
- Note all vlans in notepad and copy to all switches, then config VTP,
trunking etc
I am finding it is taking me a while to config each vlan on each switch,
would it be easier to config all vlans on all switches (via notepad), or
will I "lose" points if I have a vlan configed on a switch that is not being
used. ie it shows up via "sh vlan brie" but is not being used by the switch
(configd on access port or svi) or trunked.
Should ALL switches have ALL vlans configured even if they are used or not?
-A
This archive was generated by hypermail 2.1.4 : Sun Jul 01 2007 - 17:24:48 ART