From: Ronnie Angello (ronnie.angello@gmail.com)
Date: Tue May 01 2007 - 12:24:26 ART
At least the switch does warn you...
CAT1(config)#ip wccp web-cache
CAT1(config)#
3w5d: %L3TCAM-3-SIZE_CONFLICT: WCCP requires enabling extended routing
Ronnie
On 5/1/07, Scott Morris <smorris@ipexpert.com> wrote:
>
> It won't setup a session with the web-cache device if you don't change the
> SDM. I would assume that this means you would also not get your points on
> the exam unless you did this.
>
> HTH,
>
>
> Scott Morris, CCIE4 (R&S/ISP-Dial/Security/Service Provider) #4713, JNCIE
> #153, CISSP, et al.
> CCSI/JNCI-M/JNCI-J
> IPexpert VP - Curriculum Development
> IPexpert Sr. Technical Instructor
> smorris@ipexpert.com
> http://www.ipexpert.com
>
>
>
> -----Original Message-----
> From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
> John
> Gibson
> Sent: Tuesday, May 01, 2007 10:34 AM
> To: ccielab@groupstudy.com
> Subject: WCCP needs an SDM template command?
>
> I just wonder if any one is doing this,
>
> univercd says
>
> "You must use the extended-match keyword to support 144-bit Layer 3 TCAM
> when WCCP or multi-VRF CE is enabled on the switch."
>
> WCCP commands are accepted even when the extended-match keyword is never
> used.
>
> But we don't have a WCCP device to verify if our WCCP configuration
> command
> in the switch works as expected.
>
> __________________________________________________
> Do You Yahoo!?
> Tired of spam? Yahoo! Mail has the best spam protection around
> http://mail.yahoo.com
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
This archive was generated by hypermail 2.1.4 : Fri Jun 01 2007 - 06:55:19 ART