From: Andre Serrao (andreserrao@gmail.com)
Date: Tue Feb 27 2007 - 21:30:35 ART
For some reason, my original message didn't go through...Trying to send it
once again.
On 2/27/07, Andre Serrao <andreserrao@gmail.com> wrote:
>
> I was working on a IEWB Lab9 v3.0, question 4.5 but I think anyone can
> answer this.
>
> I changed the hello interval in the EIGRP interval to 4 seconds.
>
> However, when I enter the "show ip eigrp interfaces detail serial 0/0" I
> don't see the hello interval information there. According to Solutions
> Guide, "hello interval is 4sec" should appear just before " Next xmit
> serial <none>"
>
> Any reason?
>
> Thanks,
> Andre
>
> --------------------------
>
> Rack1R5#show ip eigrp int detail serial 0/0
> IP-EIGRP interfaces for process 100
>
> Xmit Queue Mean Pacing Time Multicast
> Pending
> Interface Peers Un/Reliable SRTT Un/Reliable Flow Timer
> Routes
> Se0/0 1 0/0 188 0/15 50
> 0
> Next xmit serial <none>
> Un/reliable mcasts: 0/0 Un/reliable ucasts: 27/64
> Mcast exceptions: 0 CR packets: 0 ACKs suppressed: 1
> Retransmissions sent: 29 Out-of-sequence rcvd: 2
> Authentication mode is not set
>
> --------------------------------
This archive was generated by hypermail 2.1.4 : Thu Mar 01 2007 - 07:38:48 ART