EIGRP hello interval

From: Andre Serrao (andreserrao@gmail.com)
Date: Tue Feb 27 2007 - 05:18:50 ART

• Next message: Shine: "Re: bpdugaurd feature on Glabal configuration"
• Previous message: Andre Serrao: "How to speed up Inverse-arp?"
• Next in thread: Andre Serrao: "Re: EIGRP hello interval"
• Maybe reply: Andre Serrao: "Re: EIGRP hello interval"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

I was working on a IEWB Lab9 v3.0, question 4.5 but I think anyone can
answer this.

I changed the hello interval in the EIGRP interval to 4 seconds.

However, when I enter the "show ip eigrp interfaces detail serial 0/0" I
don't see the hello interval information there. According to Solutions
Guide, "hello interval is 4sec" should appear just before " Next xmit
serial <none>"

Any reason?

Thanks,
Andre

--------------------------

Rack1R5#show ip eigrp int detail serial 0/0
IP-EIGRP interfaces for process 100

                        Xmit Queue Mean Pacing Time Multicast
Pending
Interface Peers Un/Reliable SRTT Un/Reliable Flow Timer
Routes
Se0/0 1 0/0 188 0/15 50 0
  Next xmit serial <none>
  Un/reliable mcasts: 0/0 Un/reliable ucasts: 27/64
  Mcast exceptions: 0 CR packets: 0 ACKs suppressed: 1
  Retransmissions sent: 29 Out-of-sequence rcvd: 2
  Authentication mode is not set

--------------------------------

• Next message: Shine: "Re: bpdugaurd feature on Glabal configuration"
• Previous message: Andre Serrao: "How to speed up Inverse-arp?"
• Next in thread: Andre Serrao: "Re: EIGRP hello interval"
• Maybe reply: Andre Serrao: "Re: EIGRP hello interval"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Mar 01 2007 - 07:38:48 ART