Lab 1 Switching Problems

From: Noel Debouver III (noeldebouveriii@yahoo.com)
Date: Sun Jan 07 2007 - 11:53:24 ART


1.1 Find three faults, 2 points each.
  ==========================
   
  1. Wrong IP Address
  2. Wrong Subnet Mask
  3. Mac-Filter Applied to Interface Connecting to BB3
   
  1.2 Frame Relay (2 Points)
  =====================
   
  1. Configure Frame Relay on designated Routers.
  2. Don't use dynamic mapping.
  3. Interfaces must be pingable.
   
  1.3 VTP Configuration (1 Point)
  =======================
   
  1. Configure VTP Domain named CCIE.
  2. Configure mode as appropriate.
  3. All switches must use the same mode.
  4. All switches use a password of cisco.
  5. All switches must use the newest version available.
   
  1.4 Etherchannel (2 Points)
  =====================
   
  1. Configure an etherchannel between two switches as appropriate.
  2. Don't use pagp or lacp
  3. Use /30 Addressing
  4. Configure ports 11-14 and 15-18 on each switch to each appear as one link.
  5. Even vlans use the first etherchannel and odds use the second etherchannel
   
  1.5 VLAN Configuration (1 Point)
  ==========================
   
  1. Confgure vlans as required to complete this lab.
  2. Name all vlans.
  3. All switches must be the same.
   
  1.6 Layer 3 Configuration (1 Point)
  ==========================
   
  1. Configure Sw1 and Sw2 to intervlan routing with R3 having the layer 3 address
  2. Configure vlan_1000 and vlan 2000.
  3. Use the highest available ip address for the gateway.
  4. Use lowest available ip address for the client.
   
  1.7 More Etherchannel (2 Points)
  =========================
   
  1. Configure etherchannel between switch 1 and 3.
  2. Configure etherchannel between switch 2 and 3.
  3. Use pagp for one etherchannel as appropriate.
  4. Use lacp for one etherchannel as appropriate.
   
  1.8 Switch Misc. Features (4 Points)
  ===========================
   
  1. Limit inbound broadcast traffic to 40% physical speed of the f0/10 on sw2.
  2. Block incoming unknown unicast and multicast traffic on f0/10 on sw3.
  3. All etherchannel neighbors must hoold cdp information for 180 minutes.
   
  1.9 Sniffer (2 Points)
  ==================
   
  1. Port f0/20 on sw4 has an IDS attached. Configure the port to work with the IDS.
   
   
   
   
   
   
   
   
   
   

 __________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com



This archive was generated by hypermail 2.1.4 : Thu Feb 08 2007 - 23:46:55 ART